I'm mocking up the lower control arms in the frame and it's doesn't fit in easily with my new nolathane bushes.
Can someone please measure the internal width of the frame where the lower control arms bolts in. Figure that will tell me which one is out.
64-66 lower control arm measurement needed
Moderator: Moderators
Re: 64-66 lower control arm measurement needed
It is not unusual to use some persuasion to get the arm in position.
I will someday think of something clever to say.
-
- Mustang King
- Posts: 3210
- Joined: Fri Mar 04, 2011 7:57 pm
Re: 64-66 lower control arm measurement needed
See if jacko will lend you his bfh....
I'm Batman...
Crane Operator
Mammoet Australia
Rye Park Wind Farm
Crane Operator
Mammoet Australia
Rye Park Wind Farm
Re: 64-66 lower control arm measurement needed
Just prise them apart until the arm goes in easily. It will only be a few mm at most. When tightened it finds its own center. I do it on every Mustang build (last time on project Patience).
Kerry
To our wives and sweethearts. May they never meet
To our wives and sweethearts. May they never meet
Re: 64-66 lower control arm measurement needed
Not Jacko's. She is at my place ......Pinto-Pete wrote:See if jacko will lend you his bfh....
Kerry
To our wives and sweethearts. May they never meet
To our wives and sweethearts. May they never meet
Re: 64-66 lower control arm measurement needed
Thanks everyone, was shitting myself the frame mounts were cactus.
-
- Mustang King
- Posts: 3210
- Joined: Fri Mar 04, 2011 7:57 pm
Re: 64-66 lower control arm measurement needed
https://www.youtube.com/watch?v=tbU3zdAgiX8ozbilt wrote:Not Jacko's. She is at my place ......Pinto-Pete wrote:See if jacko will lend you his bfh....
I'm Batman...
Crane Operator
Mammoet Australia
Rye Park Wind Farm
Crane Operator
Mammoet Australia
Rye Park Wind Farm
Re: 64-66 lower control arm measurement needed
Pinto-Pete wrote:https://www.youtube.com/watch?v=tbU3zdAgiX8ozbilt wrote:Not Jacko's. She is at my place ......Pinto-Pete wrote:See if jacko will lend you his bfh....
Kerry
To our wives and sweethearts. May they never meet
To our wives and sweethearts. May they never meet